Grass Valley 2010RDA-16 - Manual (Page 9)

2010RDA-16 Instruction Manual 9
Installation
Module Placement in the Kameleon 2000 Frame
There are twelve slot locations in both the front and rear of a Kameleon
3 RU frame to accommodate 2000 Series modules. The 2010RDA-16
module set consists of a front media module and a passive rear module that
require two module slots.
Each 2010RDA-16 front media module plugs into the front of the 2000
frame mid-plane. The passive rear module plugs into the corresponding
rear slot to provide the input and output interface connectors. Stacked
BNCs on the passive rear module require two rear slots. A frame fully
stuffed with 2010RDA-16 front and rear modules will accommodate up to
six module sets as shown in
Figure 2 .
To install a 2010RDA-16 module set in the frame:
1. Locate a vacant slot in slot 2, 4, 6, 8, 10, or 12 of the rear of the 3 RU
frame (
Figure 2 ). The passive rear module uses two slots.
Figure 2. 3 RU Frame, Rear View
Mid-frame motherboard
with power and
communication buses
Use rear media module slots 2, 4, and 6 Use rear media module slots 8, 10, and 12
8268_05
Slot 6
Slot 4
Slot 2
Slot 8
Slot 10
Slot 12