Grass Valley 2010RDA-16 - Manual (Page 15)

2010RDA-16 Instruction Manual 15
Power Up
A red FAULT LED indicates an error situation and, with the other LEDs,
can indicate the operational conditions presented in
Table 2 . The table
describes signal output and LED indications for various input/reference
combinations and user settings.
Table 2. Indicator LEDs and Conditions Indicated
LED Indication Condition
FAULT
(red)
Off Normal operation.
On continuously Module has detected an internal fault.
Flashing AES input missing or Mode Jumper not installed
COMM
(yellow)
Off No activity on frame communication bus.
Long flash Location Command received by the module from a remote control system.
Short flash Activity present on the frame communication bus.
CONF
(yellow)
Off Module is in normal operating mode.
On continuously
Module is initializing, changing operating modes or updating firmware. Simultaneous CONF
and FAULT LEDs on indicate FPGA load error.
Flashing Indicates rate of change of paddle-controlled analog setting.
PWR
(green)
Off No power to module or module’s DC/DC converter failed.
On continuously Normal operation, module is powered.
LOCK 1
(green) Off Module does not detect a valid AES input signal on channel 1.
On continuously Valid AES input signal is present on channel 1 and module is locked to it.
LOCK 2
(green) Off Module does not detect a valid AES input signal on channel 2 (dual mode only).
On continuously Valid AES input signal is present on channel 2 and module is locked to it.