Cabling, 2010rda-16 coax passive rear module – Grass Valley 2010RDA-16 User Manual
Page 12
12
2010RDA-16 Instruction Manual
Installation
Cabling
All cabling to the modules is done on the corresponding passive rear
module (PRM) at the back of the 2000 frame. The passive rear modules for
the 2010RDA-16 is a COAX PRM with 75
Ω
BNC I/O.
Refer to the instructions that follow for cabling the COAX passive rear
module for single or dual mode.
2010RDA-16 COAX Passive Rear Module
The 2010RDA-16 passive rear module provides eighteen 75
Ω
(unbalanced)
BNC connectors for single or dual operation. Refer to
tration of the 2010RDA-16 passive rear module.
The module must be jumpered during configuration for the desired mode
of operation. Refer to
Local Onboard Module Configuration
.
Figure 6. COAX Passive Rear Module
8268_02
2010
RDA-16
J6
J7
J8
J9
J5
J3
J4
J2
J15
J16
J17
J18
J14
J12
J13
J11
J1
J10
Single Mode
Dual Mode
CH2 Out J6 – J9 and J15 – J18
CH1 Out J2 – J5 and J11 – J14
CH2 In
CH1 In
Outputs J2 – J9 and J11 – J18
CH 1
OUT
IN 2
IN 1
CH 2
OUT