H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 30)

24
Figure 27 Setting the terminal emulation in Test Properties dialog box
Connecting the Ethernet cables
Connecting a copper Ethernet port
1. Connect one end of the Ethernet cable to the copper Ethernet port of the device, and the other end
to the Ethernet port of the peer device.
2. After powering on the device, examine the LEDs of the fixed copper Ethernet port.
For more information about the LED description, see "Appendix B LEDs."
Connecting a fiber port
No transceiver module is provided with the device. The device supports only LC-type fiber connectors. For
transceiver module specifications, see "Appendix A Chassis views and technical specifications."
Follow these guidelines when you connect an optical fiber:
• Never stare into an open fiber port, because invisible rays might be emitted from the fiber port.
• Cover the dust plug if no optical fiber connector is connected to the fiber port.
• Never bend or curve a fiber when connecting it. After a fiber is installed correctly, the bend radius
must be not less than 10 cm (3.94 in).
• Keep the fiber end clean.