H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 20)

14
To install the device by using front mounting brackets and slide rails:
1. Wear the ESD-preventive wrist strap and verify that the rack is well grounded and sturdy enough.
2. Use the screws packed with the front mounting brackets to attach the front mounting brackets to the
device, as shown in
Figure 8 .
3. Install the slide rails to the rack. See Figure 14 for reference.
Figure 14 Installing slide rails
4. Holding both sides of the device, push the device to the rack along the slide rails, as shown
in
Figure 15 . Make sure the chassis bottom makes close contact with the slide rails.
Figure 15 Installing the device to the rack
5. Attach the front mounting brackets on the device to the front rack posts with M6 screws and cage
nuts.