H3C Technologies H3C SR8800 - Manual (Page 26)

20
c. Enter the name outbound, select GigabitEthernet2/1/8 from the list, and click Add to add it
into the Interface box.
d. Click Apply.
# Add segment 10:
e. Select System Management > Network Management > Segment Configuration from the
navigation tree.
Figure 8 Adding segment 10
b. Select 10 from the Segment No. list.
c. Select inbound from the Internal Zone list.
d. Select outbound from the External Zone list.
e. Click Apply.
# Configure the collaboration policy and rules:
f. Select System Management > Network Management > ACFP Policy from the navigation tree.
g. Click Create Policy.
Figure 9 Configuring collaboration policy
c. Enter the description t1.
d. Select GigabitEthernet2/1/7 from the Source Interface list.
e. Select the Enable option.
f. Select 0 from the Priority list.
# Add rule 1:
g. Click Add on the Configure Rule tab as shown in Figure 9 . After the page for creating a rule
pops up, perform the following configuration as shown in Figure 10 .