H3C Technologies H3C S5800 Series Switches - Manual (Page 25)

21
Installing the power module
Table 7 Install the power module
Procedure Description
Install a power
module
Hold the handle of the power module and place
the module to the installation position of the
chassis, and then push the module until the rear
end of the module touches the chassis.
Lock the
module Fix the captive screws on the panel to secure the
power module to the chassis.
Removing the power module
Table 8 Remove the power module
Procedure Description
Release the
screws
Release the captive screws on the panel.
Release the
module Pull the handle to detach the module from the
connector.
Pull out the
module
Hold the handle to pull the module out. (Do not
touch the module’s surface because it might be
quite hot.)