H3C Technologies H3C S6800 Series Switches - Manual (Page 40)

33
Step Command Remarks
6. Enable BGP to exchange IPv6
unicast routes with the
specified peer.
peer { group-name | ip-address }
enable By default, BGP does not exchange
IPv6 unicast routes with any peer.
7. Redistribute VPN routes.
import-route protocol [ process-id
[ allow-direct | med med-value |
route-policy route-policy-name ] * ]
By default, no routes are
redistributed into BGP.
8. (Optional.) Configure filtering
of advertised routes.
filter-policy { acl6-number |
prefix-list ipv6-prefix-name }
export [ protocol process-id ]
By default, BGP does not filter
advertised routes.
9. (Optional.) Configure filtering
of received routes.
filter-policy { acl6-number |
prefix-list ipv6-prefix-name }
import
By default, BGP does not filter
received routes.
Displaying and maintaining IPv6 MCE
Execute display commands in any view.
Task Command
Display information about a specified
VPN instance or all VPN instances.
display ip vpn-instance [ instance-name vpn-instance-name ]
Display BGP peer group information
for a VPN instance. display bgp group ipv6 vpn-instance vpn-instance-name
[ group-name ]
Display BGP peer information for a
VPN instance. display bgp peer ipv6 vpn-instance vpn-instance-name [ group-name
log-info | ipv6-address { log-info | verbose } | verbose ]
For commands that display information about a routing table, see Layer 3—IP Routing Command
Reference.
IPv6 MCE configuration example
Network requirements
As shown in Figure 6 , the MCE device is connected to VPN 1 through VLAN-interface 10 and to VPN 2
through VLAN-interface 20. OSPFv3 runs in VPN 2.
Configure the MCE to separate routes from different VPNs and advertise VPN routes to PE 1 through
OSPFv3.