beautypg.com

Configuring ebgp between an mce and a vpn site – H3C Technologies H3C S6800 Series Switches User Manual

Page 16

background image

9

Step Command

Remarks

7.

(Optional.) Configure OSPF
to redistribute the default

route.

default-route-advertise summary
cost cost

By default, OSPF does not
redistribute the default route.
This command redistributes the
default route in a Type-3 LSA. The

MCE advertises the default route to

the site.

8.

Create an OSPF area and
enter OSPF area view.

area area-id

By default, no OSPF area is
created.

9.

Enable OSPF on the interface

attached to the specified
network in the area.

network ip-address wildcard-mask

By default, an interface neither
belongs to any area nor runs

OSPF.

Configuring EBGP between an MCE and a VPN site

To run EBGP between an MCE and a VPN site, you must configure a BGP peer for each VPN instance

on the MCE, and redistribute the IGP routes of each VPN instance on the VPN site.
You can configure filtering policies to filter received routes and advertised routes.

1.

Configure the MCE:
Routes redistributed from OSPF to BGP have their OSPF attributes removed. To enable BGP to
distinguish routes redistributed from different OSPF domains, you must enable the redistributed

routes to carry the OSPF domain ID by configuring the domain-id command in OSPF view. The
domain ID is added to BGP VPN routes as an extended community attribute.
To configure the MCE:

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enter BGP view.

bgp as-number N/A

3.

Enter BGP-VPN instance
view.

ip vpn-instance vpn-instance-name N/A

4.

Configure an EBGP peer.

peer { group-name | ip-address }
as-number as-number

By default, no BGP peer is
configured.

5.

Enter BGP-VPN IPv4
unicast address family

view.

address-family ipv4 [ unicast ]

N/A

6.

Enable BGP to exchange

IPv4 unicast routes with the
peer.

peer { group-name | ip-address }
enable

By default, BGP does not
exchange IPv4 unicast routes

with any peer.