Verifying the configuration – H3C Technologies H3C S6800 Series Switches User Manual

Page 26

# On PE 1, create VLAN 30 and VLAN-interface 30, bind the VLAN interface with VPN instance

vpn1, and configure an IP address for the VLAN interface.

[PE1] vlan 30

[PE1-vlan30] quit

[PE1] interface vlan-interface 30

[PE1-Vlan-interface30] ip binding vpn-instance vpn1

[PE1-Vlan-interface30] ip address 30.1.1.2 24

[PE1-Vlan-interface30] quit

# On PE 1, create VLAN 40 and VLAN-interface 40, bind the VLAN interface with VPN instance
vpn2, and configure an IP address for the VLAN interface.

[PE1] vlan 40

[PE1-vlan40] quit

[PE1] interface vlan-interface 40

[PE1-Vlan-interface40] ip binding vpn-instance vpn2

[PE1-Vlan-interface40] ip address 40.1.1.2 24

[PE1-Vlan-interface40] quit

# Configure the IP address of the interface Loopback 0 as 101.101.10.1 for the MCE and as
100.100.10.1 for PE 1. Specify the loopback interface address as the router ID for the MCE and

PE 1. (Details not shown.)
# Enable OSPF process 10 on the MCE, bind the process to VPN instance vpn1, disable OSPF
routing loop detection, and set the domain ID to 10.

[MCE] ospf 10 router-id 101.101.10.1 vpn-instance vpn1

[MCE-ospf-10] vpn-instance-capability simple

[MCE-ospf-10] domain-id 10

# On the MCE, advertise subnet 30.1.1.0 in area 0, and redistribute the static route of VPN 1.

[MCE-ospf-10] area 0

[MCE-ospf-10-area-0.0.0.0] network 30.1.1.0 0.0.0.255

[MCE-ospf-10-area-0.0.0.0] quit

[MCE-ospf-10] import-route static

# On PE 1, enable OSPF process 10, bind the process with VPN instance vpn1, set the domain ID

to 10, and advertise subnet 30.1.1.0 in area 0.

[PE1] ospf 10 router-id 100.100.10.1 vpn-instance vpn1

[PE1-ospf-10] domain-id 10

[PE1-ospf-10] area 0

[PE1-ospf-10-area-0.0.0.0] network 30.1.1.0 0.0.0.255

[PE1-ospf-10-area-0.0.0.0] quit

[PE1-ospf-10] quit

# Use similar procedures to configure OSPF process 20 between MCE and PE 1 and redistribute
VPN 2's routing information. (Details not shown.)

Verifying the configuration

# On PE 1, display the routing information for VPN 1. The output shows that the static route of VPN 1 has

been redistributed to the OSPF routing table of PE 1.

[PE1] display ip routing-table vpn-instance vpn1

Destinations : 13 Routes : 13

Destination/Mask Proto Pre Cost NextHop Interface