beautypg.com

Mce configuration examples, Network requirements, Configuration procedure – H3C Technologies H3C S6800 Series Switches User Manual

Page 22

background image

15

For other MCE related displaying and maintaining commands, such as displaying routing table

information for a VPN instance and maintaining routing sessions for a VPN instance, see Layer 3—IP
Routing Command Reference
.

MCE configuration examples

Configuring the MCE that uses OSPF to advertise VPN routes to
the PE

Network requirements

As shown in

Figure 4

, the MCE device is connected to VPN 1 through VLAN-interface 10 and is

connected to VPN 2 through VLAN-interface 20. OSPF runs in VPN 2.
Configure the MCE device to separate routes from different VPNs and to advertise the VPN routes to PE

1 through OSPF.

Figure 4 Network diagram

Configuration procedure

Assume that the system name of the MCE device is MCE, the system names of the edge devices of VPN
1 and VPN 2 are VR1 and VR2, and the system name of PE 1 is PE1.

1.

Configure the VPN instances on the MCE and PE 1:
# On the MCE, configure VPN instances vpn1 and vpn2, and specify an RD and route targets for
each VPN instance.

CE 2

VPN 1

Site 2

CE 1

VPN 2

Site 1

PE 1

PE 3

PE 2

VPN 2

192.168.10.0/24

VR 2

VPN 1

192.168.0.0/24

VR 1

MCE

FGE1/0/1

Vlan-int10

10.214.10.3/24

FGE1/0/1

Vlan-int30: 30.1.1.2/24
Vlan-int40: 40.1.1.2/24

FGE1/0/3
Vlan-int30: 30.1.1.1/24
Vlan-int40: 40.1.1.1/24

FGE1/0/2
Vlan-int20
10.214.20.3/24