beautypg.com

Configuring routing between an mce and a pe – H3C Technologies H3C S6800 Series Switches User Manual

Page 38

background image

31

Step

Command

Remarks

8.

Redistribute remote site

routes advertised by the PE
into BGP.

import-route protocol
[ process-id [ allow-direct | med
med-value | route-policy

route-policy-name ] * ]

By default, no routes are
redistributed into BGP.

9.

(Optional.) Configure
filtering of advertised routes.

filter-policy { acl6-number |
prefix-list ipv6-prefix-name }

export [ protocol process-id ]

By default, BGP does not filter
advertised routes.

10.

(Optional.) Configure
filtering of received routes.

filter-policy { acl6-number |
prefix-list ipv6-prefix-name }

import

By default, BGP does not filter
received routes.

2.

Configure a VPN site:

Step

Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enter BGP view.

bgp as-number N/A

3.

Configure the MCE as an
IBGP peer.

peer { group-name |
ipv6-address
} as-number

as-number

N/A

4.

Enter BGP-VPN IPv6 unicast
address family view.

address-family ipv6 [ unicast ]

N/A

5.

Enable BGP to exchange

IPv6 unicast routes with the

peer.

peer { group-name |

ipv6-address } enable

By default, BGP does not
exchange IPv6 unicast routes

with any peer.

6.

Redistribute the IGP routes
of the VPN into BGP.

import-route protocol
[ process-id [ allow-direct | med

med-value | route-policy
route-policy-name
] * ]

By default, no routes are
redistributed into BGP.
A VPN site must advertise VPN

network addresses to the
connected MCE.

Configuring routing between an MCE and a PE

MCE-PE routing configuration includes these tasks:

Binding the MCE-PE interfaces to IPv6 VPN instances.

Performing routing configurations.

Redistributing IPv6 VPN routes into the routing protocol running between the MCE and the PE.

Perform the following configuration tasks on the MCE. For information about configuring the PE, see the
documentation for the PE.

Configuring IPv6 static routing between an MCE and a PE

Step Command

Remarks

1.

Enter system view.

system-view

N/A