H3C Technologies H3C S10500 Series Switches - Manual (Page 14)

8
Task Remarks
Configuring the ACFP client (OAP card) Required
Configuring the ACFP server (switch)
Enabling the ACFP server
Follow these steps to configure to enable the ACFP server:
To do… Use the command… Remarks
Enter system view system-view —
Enable the ACFP server acfp server enable
Required
Disabled by default
Enabling the ACFP trap function
To make ACFP work normally, you must enable the device to send traps of the ACFP card.
After the trap function on the ACFP card is enabled, the ACFP card will generate traps to report important
events of the card.
Table 1 ACFP trap message level
Trap message Level
Context ID type changed notifications
ACFP client registration notifications
ACFP client deregistration notifications
ACSEI detects that ACFP client had no response warnings
ACFP server does not support the working mode of the
ACFP client
errors
Expiration period of ACFP collaboration policy
changed
notifications
ACFP collaboration rules are created informational
ACFP collaboration rules are removed informational
ACFP collaboration rules failed errors
Expiration period of ACFP collaboration policy timed
out
notifications
The generated traps will be sent to the information center of the device. With the parameters for the
information center set, the output rules for traps—whether the traps are allowed to be output and the
output destinations—are decided. For more information about the configuration of the parameters for the
information center, see Network Management and Monitoring Configuration Guide.
Follow these steps to enable the ACFP function: