H3C Technologies H3C S10500 Series Switches - Manual (Page 29)

Figure 9 Network diagram
3. Configuring LACP MAD detection
Configure LACP MAD detection by following these steps:
• Create an aggregate interface (also required on the intermediate switch)
• Configure the aggregation group to work in dynamic aggregation mode (also required on the
intermediate switch)
• Enable LACP MAD detection on the dynamic aggregate interface
• Add member ports to the aggregation group.(also required on the intermediate switch)
Follow these steps to configure LACP MAD detection:
To do… Use the command… Remarks
Enter system view system-view —
Assign a domain ID to the IRF
fabric
Irf domain domain-id
Required if the intermediate
device is an IRF fabric.
By default, the domain ID of an
IRF fabric is 0.
Enter Layer 2
aggregate
interface view
interface bridge-aggregation
interface-number
Create an
aggregate
interface and
enter
aggregate
interface view
Enter Layer 3
aggregate
interface view
interface route-aggregation
interface-number
Required
Use either command.
23