H3C Technologies H3C S12500 Series Switches - Manual (Page 47)

39
XGE1/0/1 srv1 0 Up
SPBM with tandem replication configuration example
Network requirements
As shown in Figure 11 , deploy an SPBM network to meet the following requirements:
• Use I-SID 3001 to extend VLAN 100 across customer sites 1, 2, and 3.
• Use tandem replication for multicast in the SPBM network.
• Assign B-VLAN 3001 to I-SID 3001.
Figure 11 Network diagram
Configuration procedure
1. Configure BEB 1:
# Create C-VLAN 100 and B-VLAN 3001.
system-view
[BEB1]vlan 100
[BEB1-vlan100]vlan 3001
[BEB1-vlan3001]quit
# Configure MST region parameters on BEB 1. Make sure B-VLAN 3001 is mapped to MSTI
4092.
[BEB1]stp region-configuration
[BEB1-mst-region]region-name spb
[BEB1-mst-region]instance 4092 vlan 3001
[BEB1-mst-region]active region-configuration
[BEB1-mst-region]quit
# Enable SPBM both globally and on the provider network port on BEB 1. Assign the provider
network port to B-VLAN 3001.