H3C Technologies H3C S12500 Series Switches - Manual (Page 41)

33
Step Command Remarks
3. Enter SPBM view. spbm N/A
4. Configure an SNMP
context for ISIS-SPB.
snmp context-name context-name
By default, no SNMP
context is configured for
ISIS-SPB.
Configuring the AP mode
The Agreement Protocol (AP) prevents temporary loops that might occur when the topologies of SPBM
neighbors do not match.
If AP is enabled, SPBM issues forwarding entries to the forwarding plane only if AP declares a topology
match.
NOTE:
In this document, "AP" refers to agreement protocol. In other documents, "AP" can also refer to access
points.
To configure the AP mode:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter SPBM view. spbm N/A
3. Configure the AP mode. ap-mode { both | multicast | off }
By default, AP is enabled for both
multicast and unicast entries. SPBM
issues a unicast or multicast entry to the
forwarding plane only if AP declares a
topology match.
Displaying and maintaining SPBM
Execute display commands in any view and reset commands in user view.
Task Command
Display MAC-in-MAC connections. display l2vpn minm connection [ vsi vsi-name ]
Display MAC-in-MAC forwarding entries
(in standalone mode). display l2vpn minm forwarding [ vsi vsi-name ] [ slot slot-number
[ cpu cpu-number ] ]
Display MAC-in-MAC forwarding entries
(in IRF mode). display l2vpn minm forwarding [ vsi vsi-name ] [ chassis
chassis-number slot slot-number [ cpu cpu-number ] ]
Display VSI information. display l2vpn vsi [ name vsi-name ] [ verbose ]
Display AP information for an ECT
algorithm on an interface. display spbm agreement-protocol status interface interface-type
interface-number ect ect-number