H3C Technologies H3C S12500 Series Switches - Manual (Page 21)

13
Configuring SPBM
Configuration restrictions and guidelines
For SPBM to operate correctly, follow the restrictions and guidelines in this section when you configure
SPBM.
Hardware restrictions
In an MDC on an SPBM node, a provider network port cannot be in the same port group as an IRF
physical port, EVI tunnel source interface, or Layer 3 Ethernet interface.
Table 3 Port groups on interface cards
Card type
Port
groups
Port assignment
48-port 1000 Mbps Ethernet
fiber interface card
48-port 1000 Mbps Ethernet
copper interface card
2
Group 1—Lowest numbered 24 ports.
Group 2—Highest numbered 24 ports.
4-port 10-Gigabit Ethernet
fiber interface card
2
Group 1—Lowest numbered 2 ports.
Group 2—Highest numbered 2 ports.
8-port 10-Gigabit Ethernet
fiber interface card
4
Group 1—Ports 1 and 2.
Group 2—Ports 3 and 4.
Group 3—Ports 5 and 6.
Group 4—Ports 7 and 8.
16-port 10-Gigabit Ethernet
fiber interface card
8
Group 1—Ports 1 and 3.
Group 2—Ports 2 and 4.
Group 3—Ports 5 and 7.
Group 4—Ports 6 and 8.
Group 5—Ports 9 and 11.
Group 6—Ports 10 and 12.
Group 7—Ports 13 and 15.
Group 8—Ports 14 and 16.
20-port 10-Gigabit Ethernet
interface card
1 All ports belong to one group.
32-port 10-Gigabit Ethernet
fiber interface card
4
Group 1—Ports 1, 3, 5, 7, 9, 11, 13, 15.
Group 2—Ports 2, 4, 6, 8, 10, 12, 14, 16.
Group 3—Ports 17, 19, 21, 23, 25, 27, 29, 31.
Group 4—Ports 18, 20, 22, 24, 26, 28, 30, 32.