H3C Technologies H3C S12500X-AF Series Switches - Manual (Page 43)

39
Figure 39 Installing a CFP2 module (S12516X-AF switch)
Installing a CXP module
CAUTION:
•
Read the following instructions before you install a CXP module. Failure to follow these instructions
might cause damage to the CXP module.
• Do not remove the dust plug from the CXP module until you are ready to connect an optical fiber to
the module.
• Before you install a CXP module, remove the optical fiber (if any) from it.
CXP modules are available in two types. One type is with a rubber pull latch and the other is with a
plastic pull latch.
The installation and removal procedures are the same for the CXP modules with a rubber or plastic pull
latch. This guide uses the CXP module with a plastic pull latch as an example.
To install a CXP module: