H3C Technologies H3C S12500X-AF Series Switches - Manual (Page 34)

30
Figure 30 Installing a switching fabric module (S12516X-AF switch)
(1) Push the switching fabric module slowly into the slot
(2) Rotate the ejector levers inward until the spring clips lock the ejector levers in place
Installing a filler panel in a switching fabric module slot
The switch comes with empty switching fabric module slots. Install a filler panel in a switching fabric
module slot if you are not to install a switching fabric module in it.
To install a filler panel in a switching fabric module slot:
1. Loosen the captive screws on the ejector levers and rotate outward the ejector levers.
2. Orient the filler panel with the side marked "Up" up. Hold the filler panel front panel near the
ejector levers with one hand and support its bottom with the other. Place the filler panel bottom
gently on the bottom guide rails for the fan tray. Align the filler panel with the switching fabric
module slot. Push the filler panel slowly into the slot along the guide rails. See callout 1 in Figure
31 .
Keep the filler panel parallel to the switching fabric module slot to avoid touching other
components in the chassis.
3. As shown by callout 2 in Figure 31 , continue to push the filler panel until the brakes on its ejector
levers touch the slot edges tightly. Simultaneously rotate the ejector levers inward.
4. Fasten the captive screws on the ejector levers.
1
2
2