Epson Apex-80 - Manual (Page 127)

The following tables describe the switches and their functions.
The first two tables summarize the two groups of switches. The
remaining table shows how to set the DIP switches for the available
international character sets.
Table D-1. DIP switch group 1
Switch
number
1-1
1-2
1-3
1-4
1-5
1-6
1-7
1-8
Function
Select condensed or normal
characters
Select slashed or unslashed zero
Select character table
Paper-out detection
Select print quality
Select international character set
Action Action
when ON when OFF
Condensed Normal
0 0
Graphics Italics
Inactive Active
NLQ Draft
See Table D-3
Table D-2. DIP switch group 2
Switch
A c t i o n
n u m b e r
Function
Action
w h e n O N w h e n O F F
2 - 1 Select page length
1 2 i n c h 1 1 i n c h
2-2 Select cut sheet feeder mode Selected Not selected
2-3 Skip-over-perforation 1 inch N o n e
2-4 A d d l i n e c a r r i a g e r e t u r n C R + L F CR only
Note: The factory setting for all switches except
1-6, 1-7, and 1-8 is OFF.
International Character Sets
Thirteen international character sets are available in Epson mode.
Eight of these are selected by DIP switches 1-6 to 1-8 and the remaining
five (Japan, Norway, Denmark II, Spain II and Latin America) can be
selected with the ESC R command, which is described in the
Command Summary (Appendix A). For the characters available in
each character set, see Appendix B.
Defaults and DIP Switches D-3