ARAG SERIE 4663 Electric Control Box 7 - 9 User Manual

Page 9

6.2.2

Fitting the connectors to the control box

Fig. 4

Legend:

1 Control unit connection (SICMA con-

nector for intermediate cable).

2 Digiblock connector (polarised con-

nector with locking collar).

3 Power socket (polarised AMP connec-

tor with locking tab. Press to lock).

Fitting the cables to the connection points: do not force the connectors by pushing
too hard or bending them; the contacts can be damaged and control box operation
compromised.

6.2.3 Connecting

SICMA

connector

Fig. 5

• Open purple connector slide (1, Fig. 5).
• Position the connector (2) onto its socket (3) and press without forcing.
• Close purple cursor slide (4) until it is fully locked.
If it is hard to be connected, check connector position.

6.2.4

Connection of control unit connectors

Fig. 6

• Remove the protective cap (1 in Fig. 6) from the valve.
• Position the gasket (2) fi tting it on the connector (3), then connect the connector by pressing it
down completely (4): be careful not to bend the electrical contacts on the valve while
inserting it.
• Screw in the screw (5) until thoroughly tightened.