How to connect di/do devices (optional), Kcm-3911 di/do connector, E 18 – ACTi Indoor Hemispheric / Fisheye Dome on Straight Wall User Manual
Page 18: Installation guide
Installation Guide
How to Connect DI/DO Devices (Optional)
Depending on your surveillance needs, you may connect digital input or output devices to your
camera to trigger events or notifications.
Digital Input (DI) devices can be used to notify the camera about an activity in the camera site. DI
can be triggers of events. For example, you can connect a “panic button” to the camera; as such
when the panic button is pressed, the alarm signal will be sent through the camera. Other
common DI device applications are emergency button, smoke detector, passive infrared sensor,
etc.
Digital Output (DO) devices are external devices that are activated by the camera upon an event
insi
de the camera. For example, you can connect an “alarm horn” to the camera; as such when
an event occurs inside the camera (e.g. detected intruder), the alarm horn will sound. Other
common DO device applications are motion-triggered lights, electric fence, magnetic door locks,
etc.
KCM-3911 DI/DO Connector
You can connect up to two DI and two DO devices to your camera.
Press and hold the orange tab as you insert the wire through the pin slot, then release the orange
tab to secure the wire.
To connect input devices (DI), map the pins to one of the pin combinations below:
Device
Pin
Mapping Instructions
Digital Input 1
(DI1)
1
GND
Connect the wires of the first input device to
GND
(Pin 1) and
DI1
(Pin 3).
3
DI1
Digital Input 2
(DI2)
5
GND
Connect the wires of the second input device to
GND
(Pin 5) and
DI2
(Pin 7).
7
DI2
7 8
6
5
4
3
2
1