Step 2: prepare the camera – ACTi Indoor Hemispheric / Fisheye Dome on Straight Wall User Manual
Page 11
Installation Guide
Step 2: Prepare the Camera
IMPORTANT:
When the camera is taken out from the box, the lens is covered by a thin film.
DO
NOT
remove this film. It is used to protect the lens from scratches or fingerprint marks which may
happen during installation. Remove this film only after the camera is securely installed and all
connections are complete.
1.
Slightly twist the cover ring counter-clockwise and pull to detach it.
2.
If the cables will be routed along the surface
, remove the cable tab from the cover ring.
If
the cables will pass through the surface
, skip this step.
3.
Install a memory card into the memory card slot of the camera, as needed.
DO NOT Remove Film !
This manual is related to the following products: