Appendices, How to connect a power adapter (optional), E 16 – ACTi Indoor Hemispheric / Fisheye Dome on Straight Wall User Manual
Page 16
Installation Guide
Appendices
This section describes the procedures in preparing the external devices that you can connect to
the camera. The camera supports DC12V power input and Digital Input and Output (DI/DO)
devices using the bundled terminal blocks. The use of these devices, however, is optional.
How to Connect a Power Adapter (Optional)
In case of using a non-PoE switch or your PoE switch has limited power supply, you can
purchase a power adapter and directly connect the camera to a power outlet. The power adapter
must be connected to the supplied terminal block before use.
To do this, follow the procedures below:
1.
Loosen the screws of the
12V
and
GND
pins of the power terminal block.
2.
Take note that a standard power adapter cable has two (2) different wires:
White stripe: Connects to 12V Pin
Connects to GND Pin