Westermo GDW-11 - Manual (Page 34)

34 6615-2203
… GDW-11 connected via CSD-V32 to analogue modem
GSM
Network
PSTN
Network
Configure the GDW-11
AT+CPIN=xxxx If PIN code required
AT&F Set the unit to factory default
AT+CBST=7,0,1 Set the bearer to V.32 protocol at 9600 bit/s
AT&W Store default settings
Configure the TD-36
AT&F Set the unit to factory default
AT&W Store default settings
SW1: 2,3,5,6 ON Set dip switch 1 to configure the serial speed and format to 9600 bit/s
8 databits, None parity, 1 stopbit
SW4: 5 ON Set dip switch 4 to configure the analogue line protocol To make switch
setting active the power must be cycled OFF -> ON
Set up the connection – The dialling modem
ATDxxxx Enter the dial command to dial the number to the remote modem
Set up the connection – The answering modem
ATA Enter the answer command when RING comes from the network
or set up ATS0=1 to answer on 1 RING signal (or more than 1).