Watson-Marlow 505Di - Manual (Page 25)

25
English
D1. Indication of previous calibration (if completed)
E1. Decision to calibrate pump to new pumphead and tubing size
F1. Select the pumphead and tubing which is fitted to pump
G1. Confirmation of user selections. Maximum pump speed is governed by pumphead fitted
H1. Decision to calibrate pump using a calibration dose
I1. Enter calibration speed and direction
J1. Pump starts to calibrate. Press stop when ready
K1. After 15 seconds pump will prompt user to stop calibrating
L1. Measure and then enter the actual volume that has been dosed during calibration
M1. Indication of pumphead, ml/rev and maximum rpm which is governed by the pumphead.
The following section flowcharts the complete Dose procedure of the 505Di. The user can use this chart to map all
possible decisions or preferred options within Dose. The map is inter-linked between pages using connecting numbers.
Where one section ends at a number, the corresponding section will begin at the same number.