DCS 500 - Manual (Page 19)

Chapter 2 - Start-Up Instructions
DCS 500B / DCP 500B Operating Instructions
IV A
2 - 7
Set this only for units of the DCP 500 series!
517 = Rated power converter current
Enter numerical value from rating plate here
518 = 500 V (fixed!); rated power converter voltage
Enter numerical value 500 V here
519 = Temperature monitoring of power section
Enter value as indicated in the table „Technical Data“ here
520 = 4
⇒
Size C4 has been selected
Coding for unit type
521 = 1 : Single bridge (2-Q) converter
⇒
on rating plate: DCP 501 xxxx
4 : Double bridge (4-Q) converter
⇒
on rating plate: DCP 502 xxxx
Coding for power section (bridge) type
507 = Rated line voltage;
Enter: Rated line voltage U
ratedline
in V * 1.05
Example: U
ratedline
= 400 V; entry for Parameter 507
⇒
420
CAUTION: Display of the line voltage feedback value is 5 % too high!
Switching thresholds referenced to the line voltage, how-
ever, are correct!
CAUTION! Please don't forget!
11202 = SAVE MOT1 SET
Save the altered values in the non-volatile memory!
Resetting the warning either by:
briefly setting ("H“ level) binary input X6:6
or
switching the electronics voltage supply OFF and ON again.
3ADW000055R0401_DCS500B_Operating Instruction_e_d