Verilink PRISM 4151 (34-00258) Product Manual - Manual (Page 21)

Configuration 3-9 PRISM 4151
Primary Dial String, Secondary Dial String: These fields
are ASCII strings for the primary and secondary call on alarm
phone numbers used in the [DIAL] mode. The strings must
include the ATDT command prefix (ex. ATDT555-1212).
The unit attempts three times to connect using the primary
number. If all three attempts fail, it will attempt three times
to connect using the secondary number (if it is not blank). If
the secondary number fails, the unit waits five minutes and
then attempts to communicate with the primary number
again. When a connection is detected, the unit outputs the
SNMP trap message and then disconnects.
Initialization String: The modem initialization string is
entered in this field. Refer to the modem’s documentation
for further information. The default setting is
ATE1Q01V1S0=1 .
Disconnection String: This field identifies the character
string to be output when the modem session is terminated.
The default setting is
ATH .
Compressed SLIP: The choices are AUTO, ENABLE, and
DISABLE. The AUTO setting allows the 4151 to negotiate
with the far end to enable or disable SLIP compression,
depending on the type of connection.
S UMMARY
The Summary screen (Figure 3-16) is a display-only screen
summarizing the unit configuration including stored mem-
ory and switch settings. The current column displays the
current unit configuration. The saved column displays the
configuration stored in memory. The switches column dis-
plays all the configuration switch settings.
Figure 3 -16 Summary Screen