Verilink NCC 2130 (880-503285-001) Product Manual - Manual (Page 27)

Configuration
Verilink NCC 2130 User Manual 3-9
Node
Administration
Commands
Table 3-5 lists the commands available on the Node
Administration Menu.
Table 3-5 Node Administration Commands
Menu Option Description Instructions
T) time Sets the time of
day.
Enter new time (hh:mm:ss): — use the format shown.
D) date Sets the date. Enter new date (mm-dd-yy): — use format shown.
I) node id Sets a numeric
identifier.
Maximum field length = ten digits, distinguishes one node
from another, each node in a network must have a unique
node id.
N) site name Sets an alpha-
numeric identifier
used to tell one
node from another.
Site Name: Tech Pubs NCC 2130 Change (Y/N)? Site Name: Tech Pubs NCC 2130 Change (Y/N)? Site Name: Tech Pubs NCC 2130 Change (Y/N)? Site Name: Tech Pubs NCC 2130 Change (Y/N)? — if yes is
selected, a second prompt appears:
New Site Name (40) New Site Name (40) New Site Name (40) New Site Name (40): — enter a site name using up to 40
alpha-numeric characters.
R) reset com ports Resets the hardware
used for Craft port
and modem or
direct PC
connections.
No confirmation is required or given, the command prompt
returns immediately.
Used if a port seems to be in a locked condition.
S) node controller
status
Produces a short
display of
information about
the NCC functions.
Baud Rate = Craft
interface session
speed.
Last Reset = time of
last power-up.
CONTROLLER STATUS CONTROLLER STATUS CONTROLLER STATUS CONTROLLER STATUS
EXECUTION = ROM
EXECUTION = ROM EXECUTION = ROM EXECUTION = ROM
BAUD RATE = 19200
BAUD RATE = 19200 BAUD RATE = 19200 BAUD RATE = 19200
RAM TEST = PASS
RAM TEST = PASS RAM TEST = PASS RAM TEST = PASS
DUART TEST = PASS
DUART TEST = PASS DUART TEST = PASS DUART TEST = PASS
LAST RESET = 5-14-98 9:19:35
LAST RESET = 5-14-98 9:19:35 LAST RESET = 5-14-98 9:19:35 LAST RESET = 5-14-98 9:19:35
RTC TIME = 5-14-98 9:29:12
RTC TIME = 5-14-98 9:29:12 RTC TIME = 5-14-98 9:29:12 RTC TIME = 5-14-98 9:29:12
P) set privileged
password
Sets password for
the privileged level
operator.
Current Privileged Password: <> Change (Y/N)? Current Privileged Password: <> Change (Y/N)? Current Privileged Password: <> Change (Y/N)? Current Privileged Password: <> Change (Y/N)?
Privileged users can make configuration changes.
U) set unprivileged
password
Sets password for
the unprivileged
level operator.
Current Unprivileged Password: <> Change (Y/N)? Current Unprivileged Password: <> Change (Y/N)? Current Unprivileged Password: <> Change (Y/N)? Current Unprivileged Password: <> Change (Y/N)?
Unprivileged users have read-only access, they can not
make configuration changes.
M) config
management channel
Calls the
Management
Channel Menu.
Required only if a dial-up modem connection will be used,
see Table 3-6 below.
X) exit menu Exits this menu. Returns to the NCC 2130 Main Menu.