Verilink NCC 2130 (880-503285-001) Product Manual - Manual (Page 15)

Verilink NCC 2130 User Manual 2-1
Chapter
2
Quick Set-Up
This section details a quick, step-by-step procedure for configuring
the NCC 2130. For this quick configuration guide, the following
assumptions are made:
• That you are using the NCC 2130 with a fractional ESF/B8ZS T1
circuit.
• That timeslots one through twelve are to be used for the one
available data port on the NCC 2130.
• That you are using a Cisco™ router for a connection to the
Internet.
Figure 2-1 Example Configuration
It is most likely that this procedure will not match your
configuration exactly. Use this chapter as a guide to the process of
installing your equipment. Chapter 3 provides complete details on
configuration covering all selectable options.
Connect to Craft
Port
Using the Craft cable supplied with the NCC 2130, connect the
modular (RJ-11) end to the port labeled C
RAFT on the front panel of
the NCC 2130. Connect the other end of the Craft cable to your PC
or terminal. If your PC has a DB-9 COM port connector, use a
standard PC-AT serial cable to complete the connection.
Set your terminal, or terminal program, to 19.2 kbit/s, 8 data bits,
no parity, one stop bit, and no flow control.
Login • Press E NTER .
• The prompt, YOUR PASSWORD? YOUR PASSWORD? YOUR PASSWORD? YOUR PASSWORD? is displayed.
• Initially there is no password, press E NTER .
• The NCC 2130 Main Menu is displayed:
NOTE: The prompt line and menu names refer to the NCC 2130 as
an IDCSU 2130. This is because an NCC 2130 is a TAC 2130
Integrated DSU/CSU to which the Craft interface and node
controller functions have been added.
NCC
2130 NET ST
AT
EQPT
CRAFT
FUNCTION
EQPT 5 7
EXE
IN OUT IN OUT NET EQPT
NET MON
Router
NCC 2130 Internet