Verilink NCC 2020 (880-503284-001) Product Manual - Manual (Page 9)

Verilink NCC 2020 User Manual 1-1
Chapter
1
Overview
This user manual describes the NCC 2020 Node Controller module,
a component of Verilink’s Access System 2000 (AS2000) platform.
The NCC 2020 is a network management module which also
functions as a T1 CSU.
Scope This manual assumes you are already familiar with the standard
AS2000 products. Where appropriate, the text refers you to a
specific Access System 2000 manual for greater detail.
Installation
Information
For information on installing and replacing shelves, modules, and
power supplies, see the manual
AS2000, The Basics .
NOTE: Do not attempt to mix NCM, NCC, and SCC node controllers in
the same node. There can be only one type of node controller
in a node.
Related Verilink
Documents
Refer to the following related AS2000 manuals:
• The NCC 2130 User Manual documents the network controller
version of the TAC 2130 Integrated T1 DSU/CSU (IDCSU).
• AS2000, The Basics provides general information about
Verilink products.
• Node Manager for Windows 95 User Manual , documents the
Verilink network management program designed to operate
under Windows™ 95 or Windows™ NT.
• Access Manager 2000 User Manual , documents the Verilink
network management program designed to operate under
Windows™ 3.1 (only).
Management
Options
The NCC 2020 Node Controller and Channel service unit module
allows users to configure directly through an ASCII terminal port
(Craft interface) or by using either of two Verilink node
management programs. This provides full control for configuration
management, performance monitoring, and maintenance.
The NCC Node Controllers support the following:
• ASCII Craft interface, local access by direct connection to the
Craft port.