Verilink NCC 2020 (880-503284-001) Product Manual - Manual (Page 32)

Configuration
3-10 Verilink NCC 2020 User Manual
Figure 3-4 Node Administration Menu
Node
Administration
Commands
Table 3-5 lists the commands available on the Node
Administration Menu.
Table 3-5 Node Administration Commands
--- NODE CONTROLLER MENU --- --- NODE CONTROLLER MENU --- --- NODE CONTROLLER MENU --- --- NODE CONTROLLER MENU ---
T) time T) time T) time T) time
D) date
D) date D) date D) date
I) node id
I) node id I) node id I) node id
N) site name
N) site name N) site name N) site name
R) reset com ports
R) reset com ports R) reset com ports R) reset com ports
S) node controller status
S) node controller status S) node controller status S) node controller status
P) set privileged password
P) set privileged password P) set privileged password P) set privileged password
U) set unprivileged password
U) set unprivileged password U) set unprivileged password U) set unprivileged password
M) config management channel
M) config management channel M) config management channel M) config management channel
X) exit menu
X) exit menu X) exit menu X) exit menu
[1,1] NEAR TAC 2010 > [1,1] NEAR TAC 2010 > [1,1] NEAR TAC 2010 > [1,1] NEAR TAC 2010 >
Menu Option Description Instructions
T) time Sets the time of
day.
Enter new time (hh:mm:ss): — use the format shown.
D) date Sets the date. Enter new date (mm-dd-yy): — use format shown.
I) node id Sets a numeric
identifier.
Maximum field length = ten digits, distinguishes one node
from another, each node in a network must have a unique
node ID.
N) site name Sets an alpha-
numeric identifier
used to tell one
node from another.
Site Name: Tech Pubs NCC 2020 Change (Y/N)? Site Name: Tech Pubs NCC 2020 Change (Y/N)? Site Name: Tech Pubs NCC 2020 Change (Y/N)? Site Name: Tech Pubs NCC 2020 Change (Y/N)? — if yes is
selected, a second prompt appears:
New Site Name (40) New Site Name (40) New Site Name (40) New Site Name (40): — enter a site name using up to 40
alpha-numeric characters.
R) reset com ports Resets the hardware
used for Craft port
and modem or
direct PC
connections.
No confirmation is required or given. The command
prompt returns immediately.
Used if a port seems to be in a locked condition.