Tri Tool 648RBL Clamshell - Manual (Page 9)

9
Model 648RBL Low Profile Clamshell
92-1238 : Rev. 070126
NOTE:
All components should be cleaned and coated with a light film of oil prior to use.
Use a clean, non-detergent oil, preferably SAE 10 (90 SSU) or lighter.
The motor warranty is void if damage occurs from contaminated hydraulic
fluid or air supply.
MAINTENANCE
If the Clamshell is operated in such a manner that the tool blocks collect
debris while cutting, the tool blocks and the feed screws should be cleaned
after each cutting operation.
RECOMMENDED MAINTENANCE SCHEDULE
Daily
Wipe the unit down and spray with rust preventative under severe humidity
conditions.
Visually inspect for loose screws, missing screws, damage, etc.
Clean-Up