Tri Tool 648RBL Clamshell - Manual (Page 24)

24
TRI TOOL INC.
92-1238 : Rev. 070126
NOTE:
Allow the Headstock to continue for three (3) revolutions to complete the
cutting operation.
Turn the Motor(s) off.
Retract the Tool Holders so that the Tool Bit(s) clear the Pipe OD.
The Tool Holders are retracted by rotating the Feed Sprocket clockwise using
the special Spanner Wrench supplied with the Clamshell.
Run the Motor(s) until the split-lines of the Headstock and the Housing match.
Loosen the Jackscrews.
Remove the Clamshell from the pipe.
When the Clamshell must be split to remove it, refer back to the information under
‘Installation of the Clamshell on an In-Line Pipe’.
You should have a complete pipe sever at this time.