Tri Tool 648RBL Clamshell - Manual (Page 13)

13
Model 648RBL Low Profile Clamshell
92-1238 : Rev. 070126
Adjustment when mounted provides the most satisfactory results.
TOOL HOLDER ADJUSTMENT
Loosen the Hold-Down Screws on the Adjustable Slide Rail.
Run the Tool Holder to the most outward position.
Using the Adjustment Set Screws, apply a light force to the side of the Adjustable
Slide Rail so that it is in positive contact with the Tool Holder.
Tool Holder Adjustment
Adjust only those screws that bear directly in-line with the Tool Holder.
Tighten the Hold Down Screws to about 12 in-lbs (1.4 N m) to 24 in-lbs (2.7 N m).
Finger tight using a Hex Key.
Using the Hex Wrench, run the Tool Holder to the inward most position.
Note any changes in the feed pressure.
Adjust the remaining Adjustment Set Screws so that the Tool Holder has a smooth,
even feel.
Run the Tool Holder the full length of the Slide Rail.