Tri Tool 648RBL Clamshell User Manual
Page 14
14
TRI TOOL INC.
92-1238 : Rev. 070126
Tightly lock the Adjustable Slide Rail in place with the Hold-Down Screws and fully
snug the adjustment set screws.
Check that the Tool Holder runs smoothly and evenly for the full length of travel.
Readjust as necessary.
The tool holder should move with some resistance.
In, general when the Slide Rail is set correctly, teh Feed Sprocket cannot be
turned by hand but may be turned easily with the Spanner Wrench.
The torque on the Spanner Wrench should be about 2 ft-lbs (2.7 N m) to 5 ft-
lbs (6.8 N m).
TRIPPER BLOCK ASSEMBLY LUBRICATION AND TRIPPER SHAFT ADJUSTMENT
Back off the half dog set screw until it disengages from the tripper shaft.
Remove the tripper shaft assembly from the block and clean off all of the old
lubrication.
Apply a fresh lubrication to the tripper shaft assembly. and reinstall it in the block.
Screw in the half dog set screw until it locates itself in the slot on the tripper shaft.
LUBRICANT RECOMMENDATIONS
The drive gears require a high string lubrication grease such as 'Chevron Utility
Grease, light
Tripper Shaft Installation