Tri Tool 648RBL Clamshell - Manual (Page 12)

12
TRI TOOL INC.
92-1238 : Rev. 070126
NOTE:
For further information see 'Lubricant Recommendations'.
TOOL BLOCK MAINTENANCE
Clean the Slide Rails, the Feed Nut, the Sprocket Assembly and the Feed Screw.
Inspect these parts for damage and replace as required.
LUBRICATE AND REASSEMBLE THE TOOL BLOCK
Use lubricant on the Feed Screw sparingly or wipe to a film condition.
Excess lubricant will collect grit and/or chips and tend to cause thread
jamming and/or damage.
Adjust the adjustable slide rail to provide a firm, but not excessive rotational
pressure on the sprocket.
The Slide Rails must be over-tightened to squeeze the oil into a thin film
against the male and female surfaces of the Slide Rails.
Reset for proper operation.
When the mounting bracket has been overstressed, the Slide Rails may
appear to loosen when mounted if they were adjusted off of the Clamshell.
Tool Block Assembly