Tri Tool 620SB Clamshell Hydraulic - Manual (Page 9)

9
Model 620SB Low Profile Clamshell, Hyd.
92-0282 : Rev. 131230
NOTE:
MAINTENANCE
Clean Up
All components should be cleaned and coated with a light film of oil prior to use.
Use a clean, non-detergent oil, preferable SAE 10 (90 SSU or lighter).
The Motor warranty is void if damage occurs from contaminated hydraulic
fluid.
If the Tool Blocks collect debris while cutting, clean the Tool Blocks and the Feed
Screws after each cutting operation.
RECOMMENDED MAINTENANCE SCHEDULE
Daily maintenance when the unit is in operation:
Wipe the unit down and spray with rust preventative under severe humidity
conditions.
Visually inspect for loose screws, missing screws, damage, etc.
After every 20 hours of actual operation:
Check adjustment of the Main Bearing pre-load.
Lubricate the male and female Tool Block Slides and the Feed Screw. Refer
to ‘Tool Block Maintenance’ located later in this section.