Tri Tool 620SB Clamshell Hydraulic - Manual (Page 14)

14
TRI TOOL INC.
92-0282 : Rev. 131230
NOTE:
Tool Holder Adjustment
Excess lubricant will collect grit and/or chips and tend to cause thread jamming and/
or damage.
Adjust the Adjustable Slide Rail to provide a firm, but not excessive rotational
pressure on the Sprocket.
The Slide Rails must be over-tightened to squeeze the oil into a thin film against the
male and female surfaces of the Slide Rails.
Reset for proper operation.
If the Mounting Bracket has been overstressed, the Slide Rails may appear to
loosen when mounted if they were adjusted off of the Clamshell.
Adjustment when mounted provides the most satisfactory results.
TOOL HOLDER ADJUSTMENT
Loosen the Hold-down Screws on the Adjustable Slide Rail.
Run the Tool Holder to the most outward position.
Using the Adjustment Set Screws, apply a light force to the side of the Adjustable
Slide Rail so that it is in positive contact with the Tool Holder.
Adjust only those screws, which bear directly in line with the Tool Holder.