Tri Tool 620SB Clamshell Hydraulic - Manual (Page 27)

27
Model 620SB Low Profile Clamshell, Hyd.
92-0282 : Rev. 131230
CAUTION:
Tool Bit is Too Shallow
Do not move Tool Bit A.
If the cut of Tool Bits B and C is too shallow for a blend with Tool Bits D and E as
shown in picture, then proceed on.
Go ahead to “If too deep a cut has been made….”.
Retract Tool Bits D and E without changing the position of Tool Bit A.
Tighten the Set Screws holding Tool Bits D and E.
Go back to “Engage the feed by pushing the Tripper Shaft in”.
If too deep a cut has been made by Tool Bits B and C as shown, then proceed to
“Loosen the Set Screws….”
Tool Bit is Too Deep