Tri Tool 620SB Clamshell Hydraulic - Manual (Page 29)

29
Model 620SB Low Profile Clamshell, Hyd.
92-0282 : Rev. 131230
Rotate the Feed Sprocket for Tool Block No. 2 counter-clockwise to bring Tool Bits
B and C back into contact with the bevel that they have previously cut.
Visually check the Feed Pin to Sprocket engagement for Tool Block No. 2.
Leave Tool Bits D and E in contact with the beveled surface made by Tool Bits
B and C as shown.
Resume the pipe cutting operation.
Go back to “When the machining operation is finished…’.