Tri Tool 602TSB Clamshell Air - Manual (Page 16)

16
TRI TOOL INC.
92-0139 : Rev.131230
The Tool Holder should move snugly.
In general, when the Slide Rail is set correctly, the Feed Sprocket cannot be turned
by hand but may be turned easily with the Spanner Wrench.
The torque on the spanner Wrench should be about 1 to 3 ft-lbs. (1 to 4 N-m).
AIR MOTOR LUBRICATION
No direct maintenance is normally required on the Air Motor.
However, the air supply must flow through a filter/regulator/lubricator (FRL) unit or
separate units before arriving at the motor.
The FRL unit must be maintained as required (frequency dependent on the basic air
supply) to keep the water trap drained, filter cleaned and the lubrication oil reservoir
filled so that a drop of oil every 2 to 5 seconds is flowing.
If the Clamshell is to be left idle for 24 hours or more after being run on ’wet’ air, it is
advisable to squirt oil directly into the motor inlet and run the motor for 2 to 3
seconds.
This will prevent rusting and ‘freezing’ of the rotor vanes.