beautypg.com

Configure the set, Initialization – Teo 8610 ISDN Phone Installation User Manual

Page 17

background image

Installation

13-280116 Rev. C

Page 17

Configure the Set ____________________________________________

ISDN configuration is performed automatically in many cases. The telephone set will detect the switch type,
set the SPID number, and download other setup parameters when these features are available from the
Telco central office.

You will be prompted for any required setup information that cannot be set automatically.

Initialization

A self-test is performed upon power up. Press any key to begin initialization with the network. Unattended
initialization begins automatically after a short random time interval. This delay prevents multiple terminals
at a site from initializing simultaneously after a power outage.

The display will show progress while establishing the communication layers. When all three communication
layers are established, the TEI (Terminal Endpoint Identifier) and switch type will be shown for two
seconds.

SPID Entry

The SPID number will be assigned automatically if the network supports AutoSPID. If there is more than
one SPID available for your terminal, you will be prompted to select your primary telephone number.

If AutoSPID is not supported, you will be prompted to enter the phone’s primary telephone number, which
is used by the phone to generate a SPID number. Enter the number with the dial pad, and then press the

DONE

key.

ÅBKSP (backspace) deletes the previous digit.

National ISDN

– enter your full 10-digit telephone number

(including area code)

5ESS Custom ISDN – enter your 7-digit telephone number

Parameter Download (National ISDN only)

Parameter Download is a network feature that Identifies Call Appearance and Feature Activator keys that
are assigned to your line so that your phone may be configured automatically.

Note: Speed Dial, DSS keys, and other user preference settings are not configured by Parameter

Download.

If Parameter Download is not supported, the following screen may appear momentarily, prompting you to
manually configure the telephone at a later time (see page 20).

Automatic Button Detection (5ESS Custom ISDN only)

Press each multifunction key. The phone will discover the key's network assignment. Keys that have no
network assignment may be used for speed dialing – please refer to page 24.

L1:OK L2:OK TEI:123
L3:OK SWITCH=5ESS NI-X

ENTER PRIMARY PHONE #
999-555-1243 ←BKSP

NO PARAMETER DOWNLOAD
PRESS SETUP TO CONFIGURE