Line and power connections, Handset/headset – Teo 8610 ISDN Phone Installation User Manual
Page 11

Installation
13-280116 Rev. C
Page 11
Line and Power Connections
Power for the telephone may be provided on PS1 (phantom power on the transmit and receive pairs from
the NT1) or PS2 (power on pins 7 and 8). Tone Commander manufactures NT1 products that supply power
on both PS1 and PS2. Contact Tone Commander or visit www.tonecommander.com for more
information.
WARNING: If a separate power supply is used to provide PS2 power to the
telephone, make sure that the output ground of the NT1 power supply and the
PS2 power supply are connected (with the correct polarity) to a common ground
reference point or electrical damage to the telephone may occur.
• Set
both power jumpers to PS1 or PS2 as required. PS2 powering is used in most applications.
• Using an 8-conductor line cord, connect the S/T IN jack on the telephone to the TERMINAL jack on the
NT1. Route the cord under the guide tabs in the phone base.
Pin #
Signal
Wire Color
T568 A
T568 B *
(AT&T 258A)
5 Tx-
WHT-BLU
WHT-BLU
4 Tx+ BLU
BLU
1
unused
WHT-GRN WHT-ORN
2
unused
GRN ORN
3 Rx+
WHT-ORN
WHT-GRN
6 Rx- ORN
GRN
7 -48V
WHT-BRN
WHT-BRN
8 GRD BRN
BRN
* T568 B jacks are recommended; they allow conventional station pair ordering when connecting to
S/T punchdown blocks on NT1 racks.
Handset/Headset
• Plug the supplied handset or a compatible headset into the jack on the left side of the telephone.
Modular Jack Pinout