3 installation – Teletronics EZ Bridge 802.11G User Manual
Page 9

9
2.3 Installation
Preparation for Installation
Before you actually install your 802.11g WLAN Access Point, please ensure
that all the items listed in “1.4 System Requirements” are prepared, and
then choose the place with the consideration of power outlet and network
connection to install the Access Point.
To avoid causing any damage to the Access Point hardware device, please
do not power up the device before you start to connect it to the port on your
PC.
Also notice that a full installation of your Access Point includes not only the
hardware installation but also the network configuration on your PC. Check
the following section -“Hardware Installation” and the next chapter -
“Configuring Windows for IP Networking” to obtain complete details.
Hardware Installation
Follow the procedures below to fully install your Access Point hardware
device:
1.
Select a suitable place on the network to install the Access Point.
Ensure the Access Point and the DSL/cable modem are powered off.
For best wireless reception and performance, the Access Point should
be positioned in a central location with minimum obstructions between
the Access Point and the PCs.
2.
Connect one end of Ethernet cable to Access Point and the other to
switch or hub, and then the Access Point will be connected to the
10/100 Network.
3.
Connect the power adapter to the power socket on your Access Point.
4.
Last but not the least, check the LEDs on the Access Point to confirm
if the status is okay.
5.
Now the hardware installation is complete, and you may proceed to
the next chapter –“Configuring Windows for IP Networking” for
instruction on setting up network configurations.