Teletronics EZ Bridge 802.11G - Manual (Page 56)

56
Appendix E: TROUBLESHOOTING
Symptom: Power LED off
Resolution:
Connect the power adapter to your G Series Wireless AP and plug it into
the power outlet.
Note: Only use the power adapter provided with your AP. Using any other
adapter might damage your G Series Wireless AP.
Symptom: Can not setting G Series Wireless AP through web browser
Resolution:
The Ethernet cable (RJ45-crossover) must plug to LAN port of G Series
Wireless AP.
Check that the IP address in the URL field is correct.
Check your host PC IP address. If the IP address of G Series Wireless AP
is 192.168.1.240 then your IP of host PC must set 192.168.1.1~239.
Symptom: Forgot IP address
Resolution:
If you forgot the IP address of G Series Wireless AP you can press reset
button to restore the default factory settings by pressing this button for five
seconds. The default IP is 192.168.1.240.
Symptom: Can not setting G Series Wireless AP from a Wireless LAN
card
Resolution:
Make sure that the Mode, SSID, Channel and encryption settings are set
the same on each Wireless LAN card.
Make sure that your computer is within range and free from any strong
electrical devices that may cause interference.
Check your IP Address to make sure that it is compatible with the G Series
Wireless AP.