Teletronics WL-CPE-ROUTER - Manual (Page 12)

Teletronics International Inc. CPE Complete User Manual
Page 11 of 27
Step 6: Select Static and Default Routes option from the menu on the left. enter the
values into the fields as in the below screen shot. Click on the Create button
when you have finished, and then click the Save button at the top left of the
screen.
Step 7: Select IP Masquerading (NAT) from the CPE menu on the left. From here
you can set the CPE to perform IP Masquerading from either the Ethernet card
or the radio card. By default, this function is disabled. Update your settings
if you make any changes from the default setting.
Step 8: Select Slot 1, under the Configure Wireless Adapter option, from the CPE
Configuration Menu on the left. There are 3 different Wireless Network
Cards supported by the CPE Configuration Utility Software. (Please see
section 1.0 Minimum System Requirements). The following sections are
Wireless Network Card specific. Please refer to the appropriate section for
your brand of card.