Teletronics WL-CPE-ROUTER - Manual (Page 11)

Teletronics International Inc. CPE Complete User Manual
Page 10 of 27
Step 4: Setting up the ether1 adapter. Click on the default IP (192.168.1.1) to
modify it. The default values will appear in the IP, Net Mask, and Comment
fields. Make your modifications, and then click on the Modify button.
After your modification have been made, checks will appear at the right to
indicate weather or not your changes were appropriate. If you have chosen
IPs that are in conflict, you will be notified with "x"s.
Appropriate Modification Inappropriate Modification
•
Important Note: Now that you have modified your ether1 adapter, you must enter
the CPE Configuration Utility through the new IP, in this case, https://192.168.3.1.
Step 5: Setting up the wlan1 adapter. By default, the wlan1 adapter is not setup.
Enter these following values into the following fields:
When you have completed value entries, click the Create button. If there are
no IP conflicts, the software will allow the modifications.