Teac US-1200 - Manual (Page 8)

8
TASCAM US-1200
2 – Names and Functions of Parts
Rear panel
9 USB port
Use the included USB cable to connect the unit to a
computer. (Only USB 2.0 is supported.)
CAUTION
• USB 1.1 is not supported.
• When connected to a USB 3.0 port, it will function in High
Speed mode equivalent to USB 2.0 (480 Mbps maximum).
• This unit does not support computer suspend (sleep) mode,
so the unit might not function properly after this mode
ends. If this occurs, put the unit into standby mode and turn
it on again or disconnect and reconnect the USB cable.
0 OUTPUT (BALANCED) L/R jacks
These are standard balanced TRS jacks for analog monitoring
output.
These output the signals set by the LINE OUTPUTS item on
the INTERFACE page of the Mixer Panel.
Use the MON knob on the front of the unit to adjust the
output level.
Connect monitor speakers, for example, to these jacks.
(Tip:HOT, Ring: COLD, Sleeve: GND)
q DC IN 12V connector
Connect the included AC adapter (GPE248-120200-Z) here.