Teac US-2X2 - Manual (Page 10)

10
TASCAM US-2x2/US-4x4
Connecting the power
US-4x4
Use the included 12V AC adapter (GPE248-120200-Z)
to connect a power supply to the unit as shown
below.
The AC adapter for the US-4x4 includes two types of
outlet plugs. Attach the type of plug that matches the
power outlet that you are using. Please see “Changing
the outlet plug” in the Reference Manual for instruc-
tions about how to do this.
Power outlet
GPE248-120200-Z (included)
DC plug
8 Changing the outlet plug (US-4x4 only)
$ % 2
1
5
3
4
1 Move the latch on the AC adapter in the direction
of the arrow.
2 Pull off the outlet plug.
3 Replace it with the other outlet plug (A or B).
4 Move the latch on the AC adapter in the direction
of the arrow again.
5 Attach the outlet plug to the AC adapter.
This completes changing the outlet plug.
After changing the outlet plug, confirm that
is not loose or crooked and that everything is
normal before plugging it into an outlet
CAUTION
Do not use the adapter if there is anything
abnormal about the plug after changing it. Use
when the plug is abnormal could cause fire or
electric shock. Contact the retailer where you
purchased the unit or a TEAC service center (see
page 2) to request repair.
US-2x2
Normally, when a US-2x2 is connected to a computer,
it will operate using USB bus power, so a separate
power supply is not necessary. However, when
using the unit connected to an iOS device or when
not using USB bus power, a separate AC adapter
designed for use with this unit (TASCAM PS-P520,
DC5V) is necessary. In this case, connect the power
source to the unit as shown below.
DC plug
Power outlet
TASCAM
PS-P520 (sold separately)
CAUTION
Always use the AC adapter designed for use
with the unit: GPE248-120200-Z for the US-4x4
or TASCAM PS-P520 for the US-2x2. Using a
different AC adapter could cause malfunction,
overheating, fire or other problems.